Crown Handle Pivot Bushing 0.906 in OD – BS-1112

This handle pivot bushing is built for the tiller handle pivot on Crown PE 3000 walkie pallet jacks, providing the low-friction bearing surface that lets the handle swing smoothly through its operating range. The bushing also fits equivalent handle pivot points across Toyota, Hyster, Yale, Caterpillar, and Mitsubishi walkie equipment that share compatible pivot dimensions.

It measures 0.906 inches in outside diameter, 0.787 inches in inside diameter, and 0.787 inches in length, with a light weight of 0.1 pounds consistent with a small nylon or bronze bushing rather than a metal bearing assembly. The close tolerance between the bushing's inside and outside diameters is what keeps the handle pivot free of the play that would otherwise develop from metal-on-metal contact.

As a wear item, a pivot bushing gradually wears from the constant back-and-forth motion of tiller operation, and once it wears thin, the handle develops play or wobble at the pivot point. This typically shows up as looseness in handle steering response or a knocking sound during direction changes. Replacing the bushing restores a tight, controlled pivot connection on the PE 3000 walkie pallet jack handle.