$2.91
This washer fits Crown and Raymond equipment and measures 1.5 by 1.5 by 0.1 inches, weighing 0.15 pounds. As a washer, it seats under a bolt head or nut to distribute clamping load across a wider surface and protect the material beneath the fastener. It serves as a replacement washer for the Crown and Raymond positions that called for this size.
Flat steel washer measuring 1.5 inches square and about 0.1 inch thick, cataloged for Crown and Raymond lift trucks. Set under a bolt head or nut, it spreads clamping load across a wider area of the mounting surface, protecting softer material from the fastener digging in and helping keep the joint tight as it is torqued. The broad square face suits it to bracket and panel mounting points where a small round washer would bear on too little area.
Match the center bore to the bolt diameter it seats on, since a washer bored too large will not spread load evenly across the joint.
| Type | Washer |
|---|---|
| Equipment | Crown |
| Manufacturer Part Number | RA771-225 |
| Weight (lbs) | 0.15 |
| Length (in) | 1.50 |
| Width (in) | 1.50 |
| Height (in) | 0.1 |
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | RA771-225 |
|---|---|
| Product ID | 11147 |
| Short Link | https://forkliftsetc.net/?p=11147 |
| OEM Number | RA771-225 |
| Part Number |
|---|
| 800019238 |
| AD002168 |
| AD56002024 |
| AD56002168 |
| ADKE004238 |
| AM56002024 |
| AM56002168 |
| AMKE004238 |
| CK56002024 |
| CK56002168 |
| CR75404-W |
| CTNA070008 |
| CTNA70008 |
| CU00571G5 |
| CU00679G3 |
| EZ00571-G5 |
| EZ00571G05 |
| EZ00571G5 |
| EZ00679G03 |
| EZ00679G3 |
| GN1255760 |
| HW-1231 |
| KOYMR002168 |
| KT56002168 |
| LP1069-1186 |
| MBNA070008 |
| MBNA70008 |
| RA771-225 |
| SYCR75404-W |
| UKNA070008 |
