$32.94
This Raymond retaining ring seats into a machined groove and springs into place, its spring tension locking a bearing, shaft, or pin against axial movement without threads or fasteners. Once seated it takes the end load that would otherwise let the component walk out of position, holding the assembly together through its working travel.
Seated into a machined groove, this Raymond snap ring locks a bearing, shaft, or pin against axial movement, holding an assembly together without threads or fasteners. It drops into the groove it was sized for and springs into place, and its spring tension keeps it seated while it takes the end load that would otherwise let the component walk out of position.
A retaining ring is a precise fit, not a general-purpose part. It has to match both the groove it seats in and the load it holds, which is why it is renewed rather than reused once removed, since a ring that has been sprung open loses some of its holding tension.
Match the groove diameter and the ring thickness to the part coming off, since a retaining ring that is oversized will not seat in the groove and one that is undersized will not hold its load.
| Type | Snap Ring |
|---|
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | RA1017035 |
|---|---|
| Product ID | 14419 |
| Short Link | https://forkliftsetc.net/?p=14419 |
| Part Number |
|---|
| RA1017035 |
