Crown Handle Harness with Thumbwheel – CR140738

Combining the operator thumbwheel with its wiring harness in one Crown assembly, this control gives the operator a rolling speed or travel input and carries that signal straight into the truck's control circuit. The thumbwheel seats in the control handle and reads operator input, while the integrated harness routes its output through the matching connectors to the truck's controller.

Supplying the control and its wiring together keeps the input device matched to its harness, so a worn or damaged handle control is replaced as a complete, pre-connected unit rather than piecing a sensor to a loom. A thumbwheel control wears at its contact or potentiometer surface and its detent, while the harness can chafe or lose continuity at the connectors, and either fault shows up as erratic or dead travel response.

Match the assembly to the handle series and the connector arrangement on your Crown truck, since those determine whether it seats in the handle and plugs into the existing control wiring.