$14.18
Rated at 40 amps, this bolt-down ANL-class fuse opens on overload or short circuit to protect the wiring and components on the circuit it guards. Bolt-down construction gives a low-resistance, vibration-resistant connection suited to the higher-current DC circuits on electric material handling equipment, where a blade fuse would loosen or run hot.
Rated at 40 amps, this ANL-class fuse is a bolt-down current limiter built to open on overload or short circuit and protect the wiring and components on the circuit it guards. Bolt-down construction gives a low-resistance, vibration-resistant connection suited to the higher-current DC circuits found on electric material handling equipment, where a blade fuse would loosen or run hot.
The 40 amp rating sets the continuous current the fuse carries before it opens, so the replacement has to match the circuit: undersized and it nuisance-trips, oversized and it no longer protects the wire. A fuse that opens repeatedly is signaling a fault downstream rather than a defect in the fuse.
Match the amp rating, voltage rating, and bolt-hole spacing to the fuse being replaced so it seats and protects correctly.
