Raymond 792-212/009 90-Degree Hydraulic Elbow Fitting – RA792-212-009

This 90-degree hydraulic elbow fitting is built for Raymond lift truck hydraulic circuits, redirecting fluid flow at a right angle between a hose and a port or cylinder connection. The angled design lets hydraulic lines route around chassis components without kinking a straight hose run, which reduces strain on the hose and connection points.

It is a direct replacement fitting, installing in place of the original Raymond part without modification, and it weighs just 0.04 pounds, consistent with a small brass or steel fitting body rather than a larger manifold component. The fitting measures roughly 1.5 inches in length with a 1 inch cross-section, sized for the fittings typically used in lift truck hydraulic plumbing.

As a hydraulic fitting ages, the sealing surfaces at its threaded or flared connections can wear or loosen under repeated pressure cycling and vibration, which shows up as weeping or dripping hydraulic fluid at the joint rather than a sudden failure. Replacing a worn elbow fitting before it leaks helps maintain full hydraulic pressure to the lift, tilt, or auxiliary circuit it feeds. Forklifts Etc. stocks this fitting as a Raymond-specific hydraulic component.