$977.14
This lift pump supplies the pressurized hydraulic fluid that raises the mast and forks on Raymond lift trucks. Within the hydraulic circuit, it draws fluid from the reservoir and delivers it under pressure to the lift cylinder, converting motor rotation into the flow that powers the hoist function. A worn pump shows up as slow lifting, reduced capacity, or a truck that will not raise a full load.
Pressurized hydraulic fluid to raise the mast and forks comes from this lift pump on Raymond lift trucks, the component that converts motor rotation into the flow the hoist circuit runs on. It draws fluid from the reservoir and delivers it under pressure to the lift cylinder, so every raise of a load depends on the pump holding its output.
As the pump wears internally, it loses volumetric efficiency and the symptoms show at the forks: slow lifting, reduced lift capacity, or a truck that will not raise a full load at all. Because it runs whenever the truck lifts, it is a wear item that is renewed when output falls off rather than repaired in place.
Match the pump's port arrangement, mounting, and shaft or coupling to the unit being replaced, since a lift pump has to bolt to the drive and seal into the existing hydraulic circuit to deliver its rated flow.
| SKU | RA103033-100 |
|---|---|
| Product ID | 11436 |
| Category | Hydraulic Pumps, Hydraulics |
| Brand | Raymond |
| Weight | 6 lbs |
| Dimensions | 1" L × 1" W × 1" H |
| Type | Lift Pump |
|---|---|
| Equipment | Raymond lift trucks |
| Weight (lbs) | 6.00 |
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | RA103033-100 |
|---|---|
| Product ID | 11436 |
| Short Link | https://forkliftsetc.net/?p=11436 |
| Part Number |
|---|
| RA103033-100 |
