$305.76
This pressure transducer outputs a 0 to 5 volt signal and is built for Crown lift trucks, measuring 2.06 inches long with a 0.1 by 0.15 inch cross-section. It converts hydraulic pressure into a proportional electrical signal that the truck's control system reads to monitor system pressure in real time, for functions such as lift, tilt, or load sensing.
This pressure transducer outputs a 0 to 5 volt signal and is built for Crown lift trucks, measuring 2.06 inches long with a 0.1 by 0.15 inch cross-section. It converts hydraulic pressure into a proportional electrical signal that the truck's control system reads to monitor system pressure in real time.
A 0-5v output is a common analog signal range used by lift truck controllers to track hydraulic pressure for functions such as lift, tilt, or load sensing. Because the transducer's sensing element is exposed to hydraulic pressure and fluid, it can drift out of calibration or fail outright over time, which shows up as an inaccurate pressure reading or a controller that doesn't respond correctly to actual hydraulic conditions.
Sized for Crown equipment, this pressure transducer is a direct replacement part for shops troubleshooting hydraulic pressure sensing or control faults on Crown lift trucks.
| SKU | CR137638-002 |
|---|---|
| Product ID | 11117 |
| Category | Control Valves, Hydraulics |
| Brand | Crown |
| Weight | 0.05 lbs |
| Dimensions | 2.06" L × 0.1" W × 0.15" H |
| Type | Transducer Pressure 0-5v |
|---|---|
| Equipment | Crown lift trucks |
| Weight (lbs) | 0.05 |
| Length (in) | 2.06 |
| Width (in) | 0.10 |
| Height (in) | 0.2 |
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | CR137638-002 |
|---|---|
| Product ID | 11117 |
| Short Link | https://forkliftsetc.net/?p=11117 |
| Part Number |
|---|
| CR137638-002 |
