$1.65
Toyota O-ring, a round elastomer seal that closes a stationary or moving joint on Toyota forklifts, most often sealing a hydraulic fitting, port, or bore against leakage. It seats in a groove and is squeezed between the mating faces to block fluid from passing. As a wear item, the elastomer hardens, takes a set, or nicks over time until the joint weeps and the ring is replaced.
Sealing a joint against fluid leakage, this O-ring is a round elastomer seal that seats in a machined groove and is squeezed between two mating faces so pressure cannot pass. It closes stationary and slow-moving joints, most often a hydraulic fitting, port, or bore, and does its whole job through that controlled squeeze.
An O-ring is a wear item by nature. The elastomer gradually hardens, takes a compression set, or gets nicked during service, and the joint then weeps or seeps until the ring is renewed. Replacing it is routine whenever a fitting or bore it seals is opened up.
Because O-rings are specified by inside diameter, cross-section thickness, and material, match all three to the ring coming out; a ring of the wrong section will not seal even if the diameter looks right, and the wrong compound can swell or harden in the fluid it contacts.
| Type | Oring |
|---|---|
| Weight (lbs) | 1.00 |
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | TY40418-30263-71 |
|---|---|
| Product ID | 11255 |
| Short Link | https://forkliftsetc.net/?p=11255 |
| Part Number |
|---|
| 800137021 |
| AF00249 |
| BK0009630804 |
| BKL0009630804 |
| LI0009630804 |
| LIL0009630804 |
| S-TY-006 |
| TY40418-30263 |
| TY40418-30263-71 |
| TY4041830263 |
| TY404183026371 |
| ZI0009630804 |
