Crown Roller Assembly – CR138522-001

Crown builds this roller assembly as a complete rolling unit for the chassis of its electric lift trucks, arriving as an assembled roller ready to mount rather than as a bare roller and separate bearing hardware. At about 6 pounds, it is a substantial component sized to carry load as it rolls, guiding or supporting a moving part within the mechanism it serves.

A roller is a wear part by nature. Its rolling surface and bearing take continuous contact and load, and as they wear the roller develops play or flat spots that show up as noise, drag, or rough movement, at which point the assembly is replaced to restore smooth, quiet operation. Supplying it as a complete unit means the roller and its bearing are already matched, so it goes in ready to run.

Because it is a Crown assembly made for Crown lift trucks, it corresponds to the original by design. When fitting, check the roller's outside diameter and bore against the unit coming off, since a roller must match both the track it rides and the shaft it turns on to seat and run correctly. Forklifts Etc. carries it as a direct replacement.