$4.50
Sealing a major bolted joint on Crown lift trucks, this large-format Crown gasket compresses under the bolt pattern to hold back fluid or pressure across a long joint line between two big castings or housings. Matched to the original footprint and bolt layout, it drops onto the same surface without trimming and restores a full seal across the face it was cut for.
Crown builds this gasket to seal a bolted joint on its lift trucks, and at roughly five pounds it is a large-format gasket sized to a major mating surface rather than a small port or cover. A gasket this size seals the face between two big castings or housings, compressing under the bolt pattern to hold back fluid or pressure across a long joint line where any gap becomes a leak.
As a Crown part it matches the original footprint and bolt layout of the assembly it seals, so it drops onto the same surface without trimming or refitting. Gaskets harden and take a set over time and heat cycles, which is when a once-dry joint begins to weep, so this gasket is replaced whenever the housing is opened for other service rather than reused. Installed on a clean, flat face with the bolts brought up evenly, it restores a full seal across the joint it was cut for.
