$1.95
This spiral ring is built for Crown lift trucks, measuring 1.7 by 1.95 by 0.15 inches. A spiral retaining ring seats into a groove on a shaft or in a bore, using its coiled construction to hold a bearing, gear, or other component axially in place without the sharp break point found on a standard snap ring.
This spiral ring is built for Crown lift trucks, measuring 1.7 by 1.95 by 0.15 inches. A spiral retaining ring seats into a groove on a shaft or in a bore, using its coiled construction to hold a bearing, gear, or other component axially in place without the sharp break point found on a standard snap ring.
Because a spiral ring wraps in a continuous coil rather than opening at a single gap, it distributes retention force more evenly around the groove, which helps it resist working loose under vibration. Over time, repeated installation and removal can deform the coil or wear the groove it seats in, reducing the ring's grip and making replacement necessary to keep the retained component properly located.
At just 0.15 inches thick, this ring is sized for a specific groove width on Crown equipment, making it a precise, low-cost stocking item for retaining assemblies during routine service.
