Leadhead Cable Assembly 60 Inch – 214678

Rated to move high amperage between an electric lift truck's battery and the connector it powers, this leadhead cable assembly measures 60 inches, giving enough reach to run from the battery compartment out to a mounted connection point in one continuous length. The leadhead is the terminated end that seats on the battery or power connection, molded and sealed at the factory so the copper underneath stays protected from the acid mist and moisture that collect around battery tops. Its roughly 5 pound weight reflects a conductor gauge chosen for sustained current draw rather than a light signal lead.

Battery cables in daily duty fail from the outside in: insulation hardens, terminals corrode, and resistance rises until the cable heats and voltage sags under load. Swapping in a fresh 60 inch assembly reestablishes a full gauge, low resistance link and keeps the pack delivering its rated voltage to the truck's drive and lift circuits. Match the terminal style and conductor gauge against the cable coming off, since leadhead ends and wire sizes vary by application and both have to seat and carry properly.