MR Brake Assembly – CR146571

Built for the braking system on Crown lift trucks, this brake assembly arrives as a complete unit that replaces a worn original and returns the brake to full stopping and holding force. It measures about 14.60 inches wide and 4.08 inches deep at roughly 1.2 inches thick, and weighs around 7 pounds, a footprint consistent with a mounted braking component rather than a small serviceable wear part.

Brake assemblies on electric lift trucks take a hard duty cycle, engaging repeatedly through every shift as the operator slows, stops, and holds the truck on grade. Over time the friction and actuating surfaces lose their bite and stopping distances grow, the point at which the assembly is replaced as a unit rather than adjusted. Installing a fresh assembly restores the brake to its designed performance in the location it was cataloged for.

Because braking hardware varies across Crown's model lines, check the mounting arrangement and overall dimensions against the assembly coming off the truck so the replacement seats and actuates as intended. Forklifts Etc. supplies this brake assembly as a direct replacement for the failed unit already in service.