$1.38
Seating into a machined groove to hold a bearing, gear, or shaft component against axial movement, this snap ring does that retaining job on the chassis assembly it was cataloged for. The ring holds parts fixed in position, and the design comes in internal styles seated in a bore and external styles seated on a shaft.
Seating into a machined groove to hold a bearing, gear, or shaft component against axial movement, a snap ring is the low-profile retainer that locks a stack of parts in place without a threaded fastener, and this retaining ring does that job on the chassis assembly it was cataloged for. Its spring tension holds it in the groove, and its shoulder takes the thrust that would otherwise let the retained part walk along the shaft or out of the bore.
A snap ring is replaced when it is deformed, has lost its spring temper, or has been damaged during removal, since a ring that no longer holds groove tension can pop free under vibration and release the parts it retains.
Match the ring to the groove diameter and the shaft or bore it retains, since a ring oversized or undersized for its groove will not seat and hold. Confirm whether the position calls for an internal ring seated in a bore or an external ring seated on a shaft, because the two are shaped oppositely and are not interchangeable.
| Type | Snap Ring |
|---|
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | BR48601-FS001 |
|---|---|
| Product ID | 14652 |
| Short Link | https://forkliftsetc.net/?p=14652 |
| Part Number |
|---|
| BR48601-FS001 |
