$9.46
Springing outward against a machined bore wall, the Raymond internal snap ring locks a bearing, shaft, or component against axial movement and keeps it from sliding out under load. The internal design holds parts assembled from the inside rather than clamping over an external shaft, serving as a direct axial retainer in its Raymond lift truck assembly.
Springing outward against the wall of a bore, this Raymond internal snap ring retains a bearing, shaft, or component from inside a housing, locking it against the axial movement that would let it slide out under load. The internal design suits parts assembled from within the bore rather than clamped over an external shaft.
It carries the thrust that would otherwise let the retained part walk out of position, holding the assembly stacked correctly through the vibration of daily operation. Whenever the bore it secures is opened for service, the ring is replaced, since a ring that has been sprung open or nicked no longer holds its full load.
Match the ring to the bore groove diameter and thickness on the assembly it retains, since an internal ring sized to the wrong bore will not seat against the wall or hold.
| Type | Ring, Internal Snap |
|---|
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | RA540-068-417 |
|---|---|
| Product ID | 15072 |
| Short Link | https://forkliftsetc.net/?p=15072 |
| Part Number |
|---|
| RA540-068-417 |
