$5.20
Machined straight and to size so the crank swings without bind or play, this Raymond bell crank shaft is the pivot on which a bell crank rotates, redirecting the motion of a control linkage through an angle as the mechanism drives it. It carries the side loads the linkage imposes and replaces a shaft worn at the bearing surfaces.
The pivot a bell crank rotates on, this Raymond bell crank shaft carries the crank as the control linkage drives it and redirects that motion through an angle. Machined straight and to size, it lets the crank swing freely without bind or play while carrying the side loads the linkage imposes on the pivot.
A bell crank converts the direction of a linkage's travel, and the shaft it turns on is the wear point in that joint. As the bearing or bushing surfaces wear, clearance opens up and lost motion enters the linkage, so the control the crank operates grows sloppy and imprecise before the joint eventually knocks or seizes. Replacing the shaft, usually alongside its bushings, takes that lost motion back out of the linkage.
Match the shaft diameter and length, along with the journal sizes at the bearing surfaces, to the shaft being replaced, since those dimensions govern how the crank and its bushings seat and pivot.
| Type | Bell Crank Shaft |
|---|
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | RA1052665-003 |
|---|---|
| Product ID | 15145 |
| Short Link | https://forkliftsetc.net/?p=15145 |
| Part Number |
|---|
| RA1052665-003 |
| RA1052665/003 |
| SY99-03283 |
