$55.50
Thombert supplies this Dyalon A load wheel as a complete assembly at 3.25 inches outside diameter, 6.50 inches wide, with a 2.047 inch bore, bearings pressed in at the factory. The wide tread on a small diameter gives a broad contact footprint.
This Thombert wheel runs a 3.25 inch outside diameter across a wide 6.5 inch face, the tall-and-wide profile of a load roller that carries weight over a broad contact patch under the load wheels of a lift truck. Dyalon A polyurethane gives the tread its resistance to chunking and flat-spotting under sustained load, where a softer compound would deform.
The 2.047 inch bore sets the press fit onto the axle, and the wheel is supplied complete with 6205 bearings pressed into the hub, so it mounts as a finished unit. That removes the separate step of sizing and pressing a bearing into a bare wheel.
Thombert documents this wheel fitting Hyster and Yale lift trucks. Because the 6.5 inch width and 3.25 inch diameter define where this wheel sits in the truck, match the 2.047 inch bore to the axle before installation, since a press-fit wheel seats only on a shaft cut to its bore.
