$75.84
Thombert molds this load wheel to 6.00 inches outside diameter, 4.12 inches wide, with a 3.149 inch bore, supplied as the wheel alone. The larger bore places it on heavier axle assemblies than the 2.047 and 2.440 inch families more common in this catalog.
Thombert builds this load wheel on its Dyalon A polyurethane, running 6 inches in outside diameter, 4.12 inches wide, on a 3.149 inch bore. The polyurethane tread handles the high static and rolling loads a load wheel carries on a stand-up or reach truck, resisting the abrasion, chunking, and flat-spotting that ends a softer wheel early, and it rolls quieter and easier on the floor than a steel wheel of the same size. It is supplied wheel only, without bearings, so the shop presses in or reuses the 6307 bearings the hub is bored to take.
Thombert's cross-reference table documents this wheel fitting Crown lift trucks, a common load wheel size across Crown's electric lift line. The bore governs the press fit: measure the axle or bearing seat the wheel mounts on and match it to the 3.149 inch bore, since a load wheel bored for the wrong shaft will not seat and hold under load.
