Crown Tension Bar Left Hand Remanufactured – CR125237S80R

A frame tension bar takes the push and pull loads that run through the frame of a Crown electric pallet jack, tying the structure together as a tie rod so the forces of pushing, pulling, and lifting are carried without the frame flexing. This is the left hand tension bar in Crown's tension bar lineup, built to the Type I cross-section and supplied here as a remanufactured unit restored to serviceable condition.

As a handed part, the left hand bar is specific to one side of the frame and does not substitute for the right hand version, so the side it mounts on determines which bar is correct. On an electric pallet jack this bar is part of the frame's structural linkage, and a bent, cracked, or worn bar allows movement where the frame should be rigid, which telegraphs into loose or imprecise handling. Matched to the Crown frame it was cataloged for, the remanufactured bar restores the original geometry and load path. Confirm the cross-section and the hand against the bar being replaced, since Crown's tension bar lineup spans more than one configuration.