Thombert Load Wheel 10 x 3 x 2.325 for Crown – 1027-AO

Thombert makes this Dyalon A polyurethane load wheel in a 10 inch outside diameter, 3 inches wide, with a 2.325 inch bore that presses onto the axle. The larger 10 inch diameter suits it to positions that carry a taller rolling profile, and the Dyalon A polyurethane tread absorbs heavy point loading without the chunking and flat-spotting that degrade rubber under the same duty.

Thombert documents this wheel as fitting Crown lift trucks, so it drops into the Crown load-wheel position it is cataloged for. It is the wheel-only build, without bearings installed, and is sized around a tapered LM67048 and LM67010 bearing set that the buyer supplies new or carries over from the wheel coming off. Tapered bearings take both radial and thrust load, which matters on a wheel that sees side loading as the truck maneuvers.

Because the wheel presses onto its axle, the bore governs the fit. Match the 2.325 inch bore to the axle diameter, since a press-fit wheel will not seat on a shaft cut for a different bore. Sold individually for a one-for-one swap of a worn Crown load wheel.