Thombert Load Wheel 3.25 x 6.5 x 2.047 for Hyster and Yale – 2654-303

Thombert molds this polyurethane load wheel 3.25 inches in outside diameter and a wide 6.5 inches across, with a 2.047 inch bore that governs the press fit onto the axle. It is sold as the wheel alone, without bearings, so a shop supplies new bearings or reuses the set from the wheel being replaced. The polyurethane tread carries a heavy load at low rolling resistance and resists the chunking and flat-spotting that take a softer wheel out of round.

The bore is sized for a 6205 bearing, the series this wheel runs on when it is built into an assembly. The wide 6.5 inch tread spreads the load over a long contact patch, which suits the sustained duty these wheels see in daily use. Documented fitment covers Hyster and Yale lift trucks, so the wheel serves both lines from a single part.

On a press-fit wheel the bore decides whether it seats, so match the 2.047 inch bore to the axle diameter before installing, and set the correct 6205-series bearings into the hub, since a wheel-only part relies on the buyer supplying them.