Thombert Load Wheel 4 x 2.5 x 2.047 – 2283-306

Thombert builds this load wheel on its Dyalon A polyurethane compound, a 4 inch outside diameter wheel measuring 2.5 inches wide with a 2.047 inch bore. The polyurethane tread carries heavy static and rolling loads without the chunking or flat-spotting that shortens the life of a softer wheel, and it rolls quieter and easier on warehouse floors than a steel or cast wheel of the same size. It is supplied wheel only, without bearings pressed in, so the shop supplies or reuses the bearings sized to the 8505/18 series this wheel is bored for.

Thombert's cross-reference table documents this wheel fitting BT and Prime Mover, Crown, Hyster, Linde and Baker, MCFA, Raymond, Toyota, and Yale material handling equipment, which makes it a broad-coverage load wheel across mixed electric lift and pallet truck fleets. The bore is the fit-critical dimension on a press-fit wheel: measure the axle or bearing seat the wheel presses onto and match it to the 2.047 inch bore, since a wheel bored oversized will not seat and hold on the shaft.