Thombert Load Wheel 5 x 3.88 x 2.44 for Hyster and Yale – 1444 AO

Thombert cuts this load wheel from its Dyalon A polyurethane, a 5 inch outside diameter wheel 3.88 inches wide on a 2.44 inch bore. The polyurethane tread absorbs the sustained rolling and static loads a load wheel sees on a stand-up or reach truck while resisting the abrasion and chunking that wears a softer wheel, and it rolls quieter and with less floor damage than a steel wheel of the same size. It is supplied wheel only, without bearings, so the shop presses in or reuses the 6305 bearings this wheel is bored to accept.

Thombert's cross-reference table documents this wheel fitting Hyster and Yale lift trucks. The bore is the fit-critical dimension: measure the bearing seat or axle the wheel presses onto and match it to the 2.44 inch bore, since a press-fit load wheel bored oversized will not seat and hold on the shaft. Pairing it with the correct 6305 bearing restores the original rolling fit on the truck.