Thombert Load Wheel 6 x 4.25 x 3.149 for Crown and Raymond – 2214 AO

Thombert cuts this load wheel from its Dyalon A polyurethane, a 6 inch outside diameter wheel 4.25 inches wide on a 3.149 inch bore. The polyurethane tread carries the high static and rolling loads a load wheel takes on a stand-up or reach truck, holding up against the abrasion, chunking, and flat-spotting that ends a softer wheel early, and it rolls quieter and easier on the floor than a steel wheel of the same size. It is supplied wheel only, without bearings, so the shop presses in or reuses the 6307 bearings the hub is bored to accept.

Thombert's cross-reference table documents this wheel fitting Crown and Raymond lift trucks, a common load wheel size across their electric lift lines. The bore governs whether the wheel seats: measure the axle or bearing seat the wheel presses onto and match it to the 3.149 inch bore, since a load wheel bored for the wrong shaft will not hold under load.