Thombert Load Wheel Assembly 3.25 x 6.5 x 2.047 – 2261-303-88

Thombert supplies this load wheel as a complete assembly, a non-marking polyurethane wheel with its bearings and spacer already pressed in and ready to bolt onto the axle. The wheel runs a 3.25 inch outside diameter on a wide 6.50 inch tread, and its 2.047 inch bore sets the fit onto the shaft. The non-marking tread leaves clean floors, which matters in food, pharmaceutical, and retail environments where a black rubber mark is a problem.

Because it arrives as an assembly, the greasable 6205 bearings come installed with the correct spacer, so there is no separate bearing press step during the swap. Greasable bearings let the wheel be relubricated in service rather than replaced at the first sign of drag.

Thombert's cross-reference table documents this assembly fitting Clark, Crown, MCFA, and Raymond lift trucks. Even on a pre-built assembly, verify the axle matches the 2.047 inch bore, since the wheel must seat squarely on a correctly sized shaft to run true.