Thombert Load Wheel Assembly 3.25 x 6.5 x 2.047 – 2261AOA

Thombert supplies this load wheel as a complete assembly, a Dyalon A polyurethane wheel with its bearings and spacer already pressed into the hub, built to a 3.25 inch outside diameter, a 6.5 inch width, and a 2.047 inch bore. Because it arrives assembled, the wheel bolts in as one unit with no separate bearing press step, and the 6205 bearings it carries are greasable, so they take service grease in place rather than running sealed. Dyalon A is Thombert's polyurethane wheel compound, chosen for the load capacity and flat-spot resistance a lift truck load wheel needs under its slow, concentrated working loads.

This assembly fits Clark, Crown, MCFA, and Raymond lift trucks, a documented fitment set that makes it a ready service part for a mixed fleet. Load wheels take the full load through a small contact patch and wear on a steady cycle; buying the wheel as a bearinged assembly turns a replacement into a bolt-on job instead of a press-and-fit one.

Match the 2.047 inch bore to the axle before installing, since a press-fit assembly seats only on the shaft it was sized for, and confirm the bearing bore matches the axle so the pressed-in 6205 bearings run true.