Thombert Load Wheel Assembly 3 x 3.5 x 1.85 – 2661AOA

Dyalon A polyurethane defines this Thombert load wheel, built as a complete assembly with the bearings pressed into the hub. The wheel stands 3 inches in outside diameter and 3.5 inches wide, riding on a 1.85 inch bore that sets the press fit onto the axle. The polyurethane compound carries concentrated point loads with low rolling resistance and holds its round profile against the chunking that ends a softer wheel's life early.

A 6204-12 bearing carries the hub, sized to this wheel's smaller 1.85 inch bore and duty cycle. Documented fitment covers Crown, Raymond, and Toyota lift trucks along with Atlas and Linde/Baker equipment, so the wheel serves several brands from a single stock number.

Because the wheel presses onto the axle, the bore is the dimension that decides whether it seats. Match the 1.85 inch bore to the axle diameter before installing, since a shaft even slightly off size will not hold the wheel true. Thombert manufactures the wheel and presses its bearing to the same hub, keeping the running fit matched from the factory.