Thombert Load Wheel Assembly 6 x 2.75 x 3.149 – ST-2215 AOA

Molded in Dyalon A polyurethane, this Thombert load wheel comes as a complete assembly with the bearings pressed into the hub. It measures 6 inches in outside diameter and 2.75 inches wide, riding on a large 3.149 inch bore that governs the press fit onto the axle. Dyalon A gives the wheel high load capacity and low rolling resistance while resisting the chunking and heat build-up that break down a lesser compound under continuous duty.

The assembly runs on a 6307 bearing, a greasable configuration that lets a technician re-lubricate the wheel on a service interval rather than pull it early. Documented fitment covers Clark, Crown, and Raymond lift trucks, so one wheel serves several brands across a mixed electric fleet.

The 3.149 inch bore is the controlling dimension on this press-fit wheel, so match it to the axle diameter before pressing the wheel on; a shaft off that size will not let the wheel seat square. Thombert builds the wheel and the assembly together, so the bore and hub are matched from the factory.