Thombert Load Wheel Assembly 6 x 4.12 x 3.149 for Crown – 2302AOA

Thombert delivers this load wheel as a complete assembly, its Dyalon A polyurethane tread already pressed onto a hub carrying 6307 shoulder bearings. The wheel runs 6 inches in outside diameter, 4.12 inches wide, on a 3.149 inch bore, sized for the heavier load stations on a stand-up or reach truck. Dyalon A polyurethane gives the wheel high load capacity and abrasion resistance while rolling easier and quieter than steel, and the pressed-in shoulder bearings arrive greasable, so the assembly can be relubricated in service rather than run to failure and replaced.

Because it arrives assembled, the wheel installs as one unit with no separate bearing fitting at the bench. Thombert's cross-reference table documents this assembly fitting Crown lift trucks. Confirm the axle diameter and the bearing bore before installation: the 3.149 inch bore and 6307 bearing seat must match the shaft the assembly rides on, since a press-fit load wheel will not seat correctly on an undersized or oversized axle.