Thombert Load Wheel Assembly 6 x 4.25 x 3.149 – 2214AOA

Dyalon A polyurethane gives this Thombert load wheel its load capacity and low rolling resistance, and it comes as a complete assembly with the bearings pressed into the hub. The wheel is 6 inches in outside diameter and a wide 4.25 inches across, riding on a 3.149 inch bore that sets the press fit onto the axle. The broad tread spreads a heavy load over a larger contact patch, which helps the wheel resist flat-spotting through a demanding duty cycle.

A 6307 bearing carries the hub, sized to the wheel's 3.149 inch bore and load rating. Documented fitment covers Crown and Raymond lift trucks, making this a straightforward replacement for a worn load wheel on either line.

On a press-fit wheel the bore decides whether it seats, so match the 3.149 inch bore to the axle diameter before pressing the wheel on; a shaft off that size will not hold the wheel square. Thombert manufactures the wheel and presses its bearing to the same hub, keeping the running fit consistent from the factory.