Thombert Poly Load Wheel 3.25 x 4.5 x 2.047 – 1820-AO

Thombert cuts this load wheel from its Dyalon A polyurethane in a compact 3.25 inch outside diameter, 4.5 inches wide, with a 2.047 inch bore. The wide face relative to the small diameter spreads the load across a broad contact patch, which is characteristic of a low, wide load wheel that carries weight close to the floor under a pallet truck or reach truck.

The Dyalon A polyurethane tread resists cutting and chunking and holds its shape under sustained load where rubber would flat-spot. Thombert documents the wheel as fitting Allis Chalmers, BT and Prime Mover, Big Joe, Crown, Raymond, and Toyota lift trucks, so a single part covers load-wheel positions across a wide mix of fleets. It is supplied as a wheel only, without bearings, and is sized around the 6205 bearing, which the buyer installs new or transfers from the wheel being replaced.

The bore is the dimension that decides the fit, since a load wheel presses onto its axle rather than bolting on. Match the 2.047 inch bore to the axle diameter on the truck, because a press-fit wheel will not seat on a shaft turned for a different bore.