Thombert Poly Load Wheel 3.25 x 5.91 x 2.047 – 4862 AO

Thombert casts this load wheel in Dyalon A polyurethane at a 3.25 inch outside diameter, a 5.91 inch width, and a 2.047 inch bore, the bore setting the press fit onto the axle. Dyalon A is Thombert's polyurethane wheel compound, and it gives a load wheel the load capacity and resistance to flat-spotting that a lift truck demands where the wheel sits parked under weight and then rolls slowly under it. The wheel comes as a wheel only, without bearings, so the buyer supplies fresh bearings or reuses the existing set; the hub is bored to the 6205 series and takes a greasable bearing.

This wheel fits Crown, Hyster, MCFA, Raymond, Toyota, and Yale lift trucks, a documented fitment set that makes it a broad-coverage service part for a mixed fleet. Load wheels carry the full load through a small contact patch low on the truck, so they wear on a steady cycle and are replaced routinely before the tread breaks down to the hub.

Match the 2.047 inch bore to the axle before installing, since a press-fit wheel seats only on the shaft it was sized for, and confirm the 6205 bearing seat so replacement bearings match the bore this hub carries.