Thombert Poly Load Wheel 3 x 3.5 x 1.85 – 2661AO

Molded in Dyalon A polyurethane, this Thombert load wheel runs a compact 3 inch outside diameter on a 3.5 inch tread, a small wheel sized for tight pockets on walk-behind and low-lift equipment. The 1.85 inch bore is the press-fit dimension that seats it on the axle, making it the first spec to verify. Dyalon A polyurethane resists the chunking and compression set that ends a load wheel's service life under constant reversing duty.

This is the wheel only, without bearings, so fresh or reused bearings are pressed in when the wheel is fitted. The bore is sized for the 6204-12 bearing series used at this size.

Thombert's cross-reference table documents this wheel fitting Atlas, Crown, Linde/Baker, Raymond, and Toyota lift trucks, making it a common service size across a mixed fleet. Because a press-fit wheel seats true only on a correctly sized shaft, measure the axle against the 1.85 inch bore and select the matching bearing before pressing the wheel into place.