Thombert Poly Load Wheel 4 x 2.5 x 2.047 – 2283 AO

Thombert turns this load wheel from its Dyalon A polyurethane to a 4 inch outside diameter over a 2.5 inch width, with a 2.047 inch bore sized to press onto the axle. It comes as a wheel only, without bearings, so the buyer presses in new 8505/18 bearings or reuses the existing set from the wheel being replaced. Dyalon A is Thombert's high-load urethane, chosen on a small-diameter load wheel because it carries concentrated weight without flat-spotting and resists the chunking that ends a softer wheel early.

Documented fitment covers BT/Prime Mover, Crown, Hyster, Linde/Baker, MCFA, Raymond, Toyota, and Yale lift trucks, which makes this a widely shared load wheel across a mixed electric and pallet fleet. On a wheel-only part, the 8505/18 bearing size and its greasable type are what the buyer confirms against the hardware on hand before pressing anything in.

The 2.047 inch bore governs the press fit, so match it to the axle the wheel rides before installing, since a load wheel will not seat true on a bore that does not match. Forklifts Etc. carries this Thombert wheel as a direct replacement for a worn load wheel.