Thombert Poly Load Wheel Assembly 8 x 4 x 2.44 – ST-4865 AOA

Thombert casts this load wheel assembly in Dyalon A polyurethane and it arrives complete, with the 6206 bearings already pressed into the 2.440 inch bore so it mounts as a single unit rather than a wheel a technician still has to build up. The 8.00 inch outside diameter and 4.00 inch tread width put a tall, wide contact footprint under the truck, and Dyalon A gives the tread the load capacity and abrasion resistance a polyurethane compound is chosen for, holding its shape under sustained weight where softer rubber would flatten and chunk.

The 2.440 inch bore is the fit that matters at installation, because it governs how the wheel seats on the axle, and the greasable 6206 bearings let the assembly be maintained in service rather than run to failure. Thombert documents fitment on Crown, Linde, Baker, MCFA, Raymond, and Toyota lift trucks, spanning the electric sit-down and reach applications this size of load wheel carries.

Match the 2.440 inch bore to the axle diameter before pressing the assembly on, since a load wheel cut for a larger or smaller shaft will not seat correctly or carry the load as intended.