Thombert Press-On Tire 10 x 3.5 x 8 for Crown and Raymond – 10050-AO

Thombert builds this press-on tire from Dyalon A polyurethane on a bonded steel ring, a 10 inch outside diameter running 3.5 inches wide over an 8 inch inside band. Dyalon A is Thombert's general heavy-production compound, the workhorse polyurethane that balances load capacity against wear life for equipment that runs full shifts. The narrow 3.5 inch section and smooth tread mark it as a drive or load tire for lighter electric equipment rather than a heavy counterbalance truck.

Documented fitment covers Crown and Raymond electric walkies and stackers built around an 8 inch wheel band. Polyurethane pressed onto a steel ring gives a rolling surface that outlasts rubber under the repeated starting, stopping, and cornering of pallet handling, and it will not chunk or flat-spot the way a softer rubber tire does under a parked load.

Because the tire presses onto the wheel, the 8 inch inside diameter has to match the band it seats on for the tire to hold under load, so measure the wheel band before pressing. This Thombert polyurethane tire is a direct replacement for a worn press-on at the same three dimensions.