Thombert Press-On Tire 10 x 3.5 x 8 for Crown and Raymond – 10050-B

Thombert builds this 10 inch press-on tire on a bonded steel ring, a black polyurethane tread running 3.5 inches wide over an 8 inch inside band. The narrow section and smooth, non-directional tread mark it as a drive or load position tire for lighter electric equipment such as walkies and stackers rather than a heavy lift truck. Black polyurethane is the standard choice where floor marking is not a concern, and it presses onto the wheel as a bonded unit.

Documented fitment covers Crown and Raymond electric walkies and stackers built around an 8 inch wheel band. Polyurethane pressed onto steel outlasts rubber through the repeated starting, stopping, and cornering of pallet work, holding its shape under a parked load where rubber tends to flat-spot.

Because the tire presses onto the wheel, the 8 inch inside diameter must match the band it seats on for a secure fit, so measure the wheel band before pressing. This Thombert polyurethane press-on is a direct replacement for a worn tire at the same 10 by 3.5 by 8 dimensions.