Crown Tension Bar (CR125237-019) – E-6567

This frame tension bar, also called a push-pull rod or tie rod, is a Crown part built for the lift undercarriage of Crown electric pallet jacks. It ties the frame structure together within the pallet jack's lift mechanism, transmitting the pushing and pulling forces generated as the undercarriage raises and lowers a loaded pallet.

Because this rod carries direct tension and compression loads through the undercarriage linkage on every lift cycle, it is a structural component rather than a cosmetic one; a bent, cracked, or worn tension bar can throw the lift geometry out of alignment, which shows up as uneven lift action or binding in the undercarriage. Replacing it with the correct Crown part restores the original linkage geometry the lift mechanism depends on.

At 45 pounds, this is a substantial structural forging or weldment, consistent with a load-bearing frame component rather than a small linkage pin. Ordering against the manufacturer part number ensures the tension bar matches the length and mounting points of the original part on the Crown electric pallet jack it is installed in.