Thombert Load Wheel Assembly 3.25 x 2 x 2.047 – ST-4868 AOA

At 3.25 inches in outside diameter and 2 inches wide on a 2.047 inch bore, this Thombert load wheel assembly fits the small-diameter load wheel positions found on pallet trucks and electric reach equipment. Thombert molds the tread in Dyalon A polyurethane, which gives a small wheel the load capacity and wear resistance to carry heavy point loads without chunking or flattening, the failure modes that retire an undersized rubber wheel quickly.

The wheel comes as a complete assembly with the 6205 bearing pressed into the hub, so it installs as one unit in place of a worn-out wheel with no separate bearing to source and press. A compact 3.25 inch diameter keeps the load platform low, which is why this size shows up on entry and undercarriage roller positions.

Thombert documents this wheel as fitting Crown, Hyster, Lansing, Raymond, Yale, Linde, Baker, and MCFA lift trucks. Match the 2.047 inch bore to the axle before pressing the wheel on, since the press fit holds only when the bore and shaft diameters agree.