Thombert Press-On Tire 12 x 5.5 x 8 – ST-10333

A 12 inch outside diameter over a 5.5 inch width and an 8 inch bore sets this Thombert press-on poly tire apart from its dimensional siblings, and the 8 inch bore is the number that governs the fit, since a press-on tire seats only on the wheel diameter it was pressed to match. Thombert builds it in polyurethane, the compound that carries heavy static and rolling loads on hard floors while resisting the cuts and chunking that end a softer tire early.

Documented fitment spans Allis Chalmers, Crown, Hyster, and Yale lift trucks, making this a single replacement across a mixed electric fleet. The smooth tread lays a full contact patch on the swept warehouse and dock surfaces these trucks run, holding traction and stability with a load up.

Before pressing this tire on, measure the wheel it mounts to against the 8 inch bore, because a wheel that does not match will keep the tire from seating and holding. Forklifts Etc. supplies it individually as a direct replacement for the worn tire coming off the wheel.