Thombert Load Wheel Assembly 3.25 x 5.91 x 2.047 – ST-4862 AOA

Thombert builds this Dyalon A load wheel assembly to a 3.25 inch outside diameter, a 5.91 inch width, and a 2.047 inch bore, arriving complete with its bearings already pressed into the hub. The Dyalon A tread runs at a 93A durometer, firm enough to carry a loaded lift truck without deforming yet resilient enough to shrug off the chunking and cuts a warehouse floor inflicts over a hard duty cycle. As a finished assembly, the wheel and bearings install together as one unit, which takes the field press-fitting step and the chance of a crooked bearing out of the job.

The assembly runs on a 6205-series bearing sized to the 2.047 inch bore, and the greasable bearing lets a technician re-lubricate the seat on a maintenance schedule rather than replace the wheel when the grease breaks down. Thombert documents fitment across Crown, Hyster, MCFA, Raymond, Toyota, and Yale lift trucks in its equipment cross-reference, one of the broadest coverage lists in this size for a mixed-fleet shop.

Match the 2.047 inch bore to your axle diameter before installation, since a press-fit assembly will not seat square on a shaft of the wrong diameter. Forklifts Etc. carries this Thombert assembly as a direct replacement for the worn load wheel it comes off.