Thombert Poly Load Wheel 3.25 x 2 x 2.047 – ST-4868

Thombert builds this polyurethane load wheel to a 3.25 inch outside diameter, a 2 inch width, and a 2.047 inch bore, the dimension that governs how the wheel presses onto its axle. Thombert casts the tread in polyurethane, which carries the concentrated point loads of a lift truck's load wheels without the flat-spotting and chunking that break down softer rubber under a stationary weight. It comes as a wheel only, without bearings pressed in, so the buyer supplies fresh bearings or reuses the ones already in service; the 6205 is the bearing this hub is bored for.

Documented across a wide equipment base, this wheel fits Crown, Hyster, Lansing, Linde and Baker, MCFA, Raymond, and Yale lift trucks, which makes it a common service part for a mixed fleet running several makes side by side. Load wheels ride at the load-bearing end of the truck and take the full weight of the load through a small contact patch, so they wear faster than drive tires and get replaced on a regular cycle.

Match the 2.047 inch bore to the axle before installing, since a press-fit wheel will not seat on a shaft it was not sized for, and confirm the bearing series so the new bearings match the bore this hub carries.