Thombert HyLoad Load Wheel 5 x 3.63 x 2.44 – SU-4807

Thombert builds this HyLoad polyurethane load wheel to a 5 inch outside diameter, a 3.63 inch width, and a 2.44 inch bore, with the bore fixing the press fit onto the axle. HyLoad is Thombert's polyurethane load-wheel line, and the polyurethane tread carries the concentrated, slow-rolling load a lift truck puts through its load wheels while resisting the flat-spotting and chunking that break down softer rubber under a parked weight. The wheel comes as a wheel only, without bearings pressed in, so the buyer fits new bearings or reuses the existing ones; the hub is bored to the 6305 series and takes a greasable bearing.

This wheel fits Allis Chalmers, Crown, MCFA, Raymond, and Toyota lift trucks, a documented fitment set that makes it a practical service part across a mixed fleet. Load wheels sit at the load-bearing end of the truck and take the full weight through a small contact patch, so they wear on a predictable cycle and get changed on a routine schedule.

Match the 2.44 inch bore to the axle before installing, since a press-fit wheel seats only on the shaft it was sized for, and confirm the 6305 bearing seat so replacement bearings match the bore this hub carries.