Thombert Poly Load Wheel 3.25 x 6 x 2.047 – TH-3840A

This Thombert load wheel measures 3.25 inches in outside diameter and runs a full 6 inches wide on a 2.047 inch bore, the wide face spreading load across a longer contact line than a narrow wheel of the same diameter. Thombert casts the tread in polyurethane, a compound that holds up to the concentrated, slow-rolling loads a lift truck puts through its load wheels far better than softer rubber, which tends to flat-spot and chunk under a parked weight. The 2.047 inch bore is machined to the 5205 bearing series, so the hub takes a known, widely stocked bearing.

Fitment is documented across a broad equipment base: this wheel fits Clark, Crown, Hyster, Linde and Baker, Raymond, Unicarriers, and Yale lift trucks, which makes it a practical shelf item for a service operation covering a mixed fleet. Load wheels sit low on the truck and carry the load through a small footprint, so they wear on a predictable cycle and get changed out well before the tread reaches the hub.

Before installing, match the 2.047 inch bore to the axle, since a press-fit wheel seats only on the shaft diameter it was sized for, and confirm the bearing bore so replacement bearings match the 5205 seat this hub carries.