$1,076.52
This Raymond ring and pinion set is the matched bevel gear pair in the drive axle of a Raymond lift truck, transmitting drive torque through a right angle to the wheels as the pinion turns the ring gear. Lapped to run together, the two are supplied and replaced as a set. Worn tooth faces and fatigue show up as driveline noise, backlash, and rough drive.
The ring and pinion set is the matched bevel gear pair in a drive axle that turns drive torque through a right angle and sends it to the wheels. The pinion drives the larger ring gear to rotate the axle, and the two are lapped together at the factory so their tooth faces share load evenly across the mesh.
Because the pair is lapped as a unit, it is supplied and replaced as a matched set rather than as individual gears. A worn set shows up as driveline whine, excess backlash, and a rough or clunking drive under power, the result of fatigue and wear at the tooth faces after long service under load.
Installing a fresh matched set restores a correct, quiet mesh and the proper backlash the axle was built with. Set pinion depth and backlash to specification on installation, since a mated pair only runs quietly when its mesh is adjusted correctly.
| SKU | RA1010491 |
|---|---|
| Product ID | 13963 |
| Category | Gears & Pinions, Transmission |
| Brand | Raymond |
| Weight | 15.75 lbs |
| Dimensions | 1" L × 1" W × 1" H |
| Type | Ring And Pinion |
|---|
These are the identifiers for this product. The SKU is the part number we use at Forklifts Etc. when you order. Below that you’ll also see the product ID, the OEM number when we have it, and cross-reference part numbers other manufacturers use for the same item.
| SKU Number | RA1010491 |
|---|---|
| Product ID | 13963 |
| Short Link | https://forkliftsetc.net/?p=13963 |
| Part Number |
|---|
| RA1010491 |
